Hello neighbor alpha 4 commands
The default baud rate at which the serial port will try to connect. Any numeric value between 0 and 160 is allowed, the factory default is 5. The time, in minutes, of inactivity on a Serial port connection, after which the Switch will close the connection. This command displays serial communication settings for the switch. You can use a serial cable to connect a management host directly to the console port of the switch. This section describes the commands you use to configure the console port. The client identifier is displayed in the output of the command only if DHCP is enabled with the client- id option on the network port. Whether IPv6 Stateless address autoconfiguration is enabled or disabled. This row is displayed only when the configured IPv6 protocol is dhcp.
The DHCPv6 client’s unique client identifier.
#Hello neighbor alpha 4 commands mac#
The factory default is to use the burned in MAC address. The choices are the burned in or the Locally Administered address. The MAC address which should be used for in-band connectivity. If desired, a locally administered MAC address can be configured for in-band connectivity. The burned in MAC address used for in-band connectivity. The default gateway for this IP interface. The network interface status it is always considered to be “Up”. The network interface is always considered to be up, whether or not any member ports are up therefore, the show network command will always show Interface Status as Up.
The configuration parameters associated with the switch’s network interface do not affect the configuration of the front panel ports through which traffic is switched or routed. The network interface is the logical interface used for in-band connectivity with the switch via any of the switch’s front panel ports. This command displays configuration settings associated with the switch’s network interface. This section describes the commands you use to configure a logical interface for management access. This section describes the management commands available in the EdgeSwitch CLI. This article does not apply to the EdgeSwitch X (ES-X) and EdgeSwitch XP (ES-XP) models.ġ.13 Prelogin Banner, System Prompt, and Host Name Commandsġ.15 UNMS, Discovery and Analytics CommandsĢ.3 System Information and Statistics CommandsĢ.5 Email Alerting and Mail Server CommandsĢ.7 Simple Network Time Protocol CommandsĢ.12 Serviceability Packet Tracing Commandsģ.11 Port-Based Network Access Control Commandsģ.18 DHCP Snooping Configuration Commandsģ.28 Dynamic ARP Inspection (DAI) and IP Source Guard Commandsĥ.10 Time Range Commands for Time-Based ACLs.Applicable to the latest EdgeSwitch firmware on all EdgeSwitch models.